(21-07-15, 06:16 PM)sadlonelygit link Wrote: My bad, didn't phrase it well. I have an old v1 rider so can check the wiring of the back of that. Youll find those waterproof covers are very deep and will accommodate a v1.Do you have a link as all the ones I have seen don't have 'any' depth to them, as in they are completely flat. In the meantime I have ordered one of these -
Holder and quick release strap
![[Image: 3_600x500.jpg]](http://www.ultimate-mobiles.co.uk/Media/Bundles/strap_handlebar/UA-TTRIDER-DED-HOLDER/Vehicles/Motorcycle/Scaled/3_600x500.jpg)
I'm gonna use doubled sided foam tape to firmly secure the TT into the holder and will wire-in a quick release waterproof external power connector and matching-fused loom for both bikes. Pictures to follow.
On a different note, this would be a perfect task for a 3D printer. If and when I get a hold of the clamp shown in the OP I will send it off to get it 3D copied etc.