19-07-15, 01:08 PM
I have got a 2nd hand led rear light to fit to my FZ1, it is made by Powerbronze but I have no fitting instructions so I am unsure as to the correct wiring.
I have tried searching on the net for some but I have drawn a blank, cannot find any on the Powerbronze website either.
There are 3 wires in the centre, black ,blue and yellow .
One yellow wire on the right hand side.
One blue wire on the left hand side.
So five wires in total.
I am not even sure if it is just a rear light or light plus indicators :o
Does anyone have the instructions for the light that they could email me or put them up on here?
Or a photo of the wiring on the bike if you have one fitted.
Also can anyone confirm if it is a light plus indicators or just a light?
Do I need to fit a resistor as it is an led?
I have tried searching on the net for some but I have drawn a blank, cannot find any on the Powerbronze website either.
There are 3 wires in the centre, black ,blue and yellow .
One yellow wire on the right hand side.
One blue wire on the left hand side.
So five wires in total.
I am not even sure if it is just a rear light or light plus indicators :o
Does anyone have the instructions for the light that they could email me or put them up on here?
Or a photo of the wiring on the bike if you have one fitted.
Also can anyone confirm if it is a light plus indicators or just a light?
Do I need to fit a resistor as it is an led?