Fitting FZ1000 Caliper to FZS600

[sinto607276]

PROGRESS....so refitted the brake line to the rear and the pressue pushed out the stuck piston - the dust seal was warped and chewed up but the piston is in good condition and so have ordered a new seal kit to put in.....

Better this than sending it away at more cost

As you hinted Sinto not enough pressure from the footbal pump....

Football pump? No wonder it wasn't moving :lol
But guess it would of moved if the seal was ok

Looking promising again - also have some 0.5mm washer to sort the alignemnt out on the caliper as 1.25mm seems to take it too far back to center and offline again...

shall hopefully eventually post final pics etc 

Hurry up man, we've been waiting on more pics
And your missing riding time :pokefun but then you've still to test it all for its MOT sure it'll sail through with all the foccin work you've done