|
Ivanising Done
|
23-05-15, 09:12 PM
Definitely change the float needle seat O-rings:
http://www.yamahafz1oa.com/forum/showthr...ilure+mode Set mixture screws 3 1/2 - 4 turns out. Maybe raise the needles 0.5mm. Or just go ahead and 'Ivanise' it while you're in there. 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Ivanising Done - by Falco9 - 23-04-15, 08:19 PM
Re: Ivanising Done - by Peasy - 23-04-15, 08:30 PM
Re: Ivanising Done - by fazed out - 23-04-15, 09:52 PM
Re: Ivanising Done - by Falcon 269 - 23-04-15, 09:55 PM
Re: Ivanising Done - by fazed out - 23-04-15, 10:02 PM
Re: Ivanising Done - by fazed out - 24-04-15, 06:46 PM
Re: Ivanising Done - by Neon Knight - 25-04-15, 05:04 PM
Re: Ivanising Done - by fazed - 25-04-15, 07:46 PM
Re: Ivanising Done - by andydrz - 26-04-15, 11:48 PM
Re: Ivanising Done - by fazer390 - 27-04-15, 02:57 PM
Re: Ivanising Done - by Falcon 269 - 28-04-15, 06:36 AM
Re: Ivanising Done - by sox22ufo - 22-05-15, 02:20 PM
Re: Ivanising Done - by Falcon 269 - 22-05-15, 02:41 PM
Re: Ivanising Done - by sox22ufo - 22-05-15, 03:00 PM
Re: Ivanising Done - by Falcon 269 - 22-05-15, 03:55 PM
Re: Ivanising Done - by sox22ufo - 22-05-15, 05:05 PM
Re: Ivanising Done - by sox22ufo - 22-05-15, 05:12 PM
Re: Ivanising Done - by Falcon 269 - 22-05-15, 06:46 PM
Re: Ivanising Done - by sox22ufo - 23-05-15, 09:01 AM
Re: Ivanising Done - by Falcon 269 - 23-05-15, 09:12 PM
Re: Ivanising Done - by Scottyboy - 08-06-15, 11:58 AM
Re: Ivanising Done - by mark g - 13-06-15, 09:09 PM
Re: Ivanising Done - by AyJay - 13-06-15, 10:55 PM
Re: Ivanising Done - by mark g - 14-06-15, 06:38 PM
Re: Ivanising Done - by Falcon 269 - 14-06-15, 09:41 PM
Re: Ivanising Done - by mark g - 15-06-15, 08:16 PM
|
