26-04-15, 01:56 PM
Hi red98...
Clearances were appalling....
Some were 0.06 an others were 0.35...
Reason being that the whole cylinder head was turned upside down by someone who shall remain nameless!!!
So it was a random put back together and then measure and adjust as needed
Ended up changing 9 shims, had a box of about 30 so was fine...and could re-use some that I took out
One or 2 were on the limit i.e 29 and 19 etc... but I am ok with that for now - once it turns over and runs I can always go back to it and adjust
Throttle cables are in and going to try fitting the carbs again now...
Clearances were appalling....
Some were 0.06 an others were 0.35...
Reason being that the whole cylinder head was turned upside down by someone who shall remain nameless!!!
So it was a random put back together and then measure and adjust as needed
Ended up changing 9 shims, had a box of about 30 so was fine...and could re-use some that I took out
One or 2 were on the limit i.e 29 and 19 etc... but I am ok with that for now - once it turns over and runs I can always go back to it and adjust
Throttle cables are in and going to try fitting the carbs again now...