13-04-15, 07:40 PM
Buy yourself a cheap welder, scrounge some scrap metal from a local engineering shop.... Read the tips on welding on line. Then crack on and teach yourself. That's what I did, when you get better buy yourself a better welder and you'll get better results.
Ali welding will require a TIG set up and they are big bucks, not only to buy but to run (gas/rods/nozzles). Start with MIG and take it from there, I couldn't weld for shit a few months ago, however I have just rebuilt the entire rear bumper section on the company van and built a new fold down step for it. All this came from just practising with a cheap MIG and a load of scrap metal.
Ali welding will require a TIG set up and they are big bucks, not only to buy but to run (gas/rods/nozzles). Start with MIG and take it from there, I couldn't weld for shit a few months ago, however I have just rebuilt the entire rear bumper section on the company van and built a new fold down step for it. All this came from just practising with a cheap MIG and a load of scrap metal.
Owner of Motorcycle Republic, Specialist in unfucking things that others have fucked up.