30-03-15, 11:43 PM
by Gnasher
Nov 25 05 8:13 PM
Re: breather mod
You CANT remove the filler neck, however as you rightly worked out it's only the length that's different.
If you look on the right hand side of the neck about 25mm down, you will see a very small bleed hole. All you need do is enlarge this hole, to about 8mm, DONT what ever you do use an electric drill or the hot swarf could well ignite the fuel :eek :eek :\ .
Get hold of a large cocktail umbrella lengthen the stick, pop it in the filler neck, open it and secure it so as to catch the swarf.
Use a HAND drill and go up in drill sizes until you can get it to at least 7mm, drill remove the umbrella, dont worry if any drop in they will just sink to the bottom and do nothing.
Job done
All you do now is fill the tank to this bleed hole, the bigger the hole the faster the fill.
Nov 25 05 8:13 PM
Re: breather mod
You CANT remove the filler neck, however as you rightly worked out it's only the length that's different.
If you look on the right hand side of the neck about 25mm down, you will see a very small bleed hole. All you need do is enlarge this hole, to about 8mm, DONT what ever you do use an electric drill or the hot swarf could well ignite the fuel :eek :eek :\ .
Get hold of a large cocktail umbrella lengthen the stick, pop it in the filler neck, open it and secure it so as to catch the swarf.
Use a HAND drill and go up in drill sizes until you can get it to at least 7mm, drill remove the umbrella, dont worry if any drop in they will just sink to the bottom and do nothing.
Job done
All you do now is fill the tank to this bleed hole, the bigger the hole the faster the fill.
Colin
----------------------
Ride fast, ride a red bike :-)
----------------------
Ride fast, ride a red bike :-)