18-02-15, 08:39 PM
Thanks for the replies.
Battery is charged already and has been left on trickle charge. Also had volt testers on and I am sure it was 13 volts but will test again.
Will need to make some time and pull the plugs to see if they are wet.
Need to clean the side stand up as its gunked up with lube. However I sprayed it up with WD40 to get ready to clean it, and now I have the 9k error on the rev counter which I read is overturn switch.
Not sure where the overturn switch is! Not mentioned as far as I can see in the haynes manual
http://www.manualslib.com/manual/611238/...ml?page=19
Battery is charged already and has been left on trickle charge. Also had volt testers on and I am sure it was 13 volts but will test again.
Will need to make some time and pull the plugs to see if they are wet.
Need to clean the side stand up as its gunked up with lube. However I sprayed it up with WD40 to get ready to clean it, and now I have the 9k error on the rev counter which I read is overturn switch.
Not sure where the overturn switch is! Not mentioned as far as I can see in the haynes manual
http://www.manualslib.com/manual/611238/...ml?page=19