10-01-15, 09:05 PM
(10-01-15, 08:51 PM)unfazed link Wrote: With the air box pulled right back tighten the 2 side bolts to stop the air box moving while try to get the carbs in place. Moisten a cloth with WD40 and rub it on to the edge and inside of the rubbers before you you start the fitting. Makes it easier to fit the carbs into the rubbers.
Loosen the the hose clips until the bolt is flush with the nut. Any less and they will be to tight to push the carbs on.
Keep checking that nothing is in the way as you feed them back in between the rubbers.
You will need three hands to get one of the cables on :lol . I usually jam the throttle open full to put that one on it makes it easier, just make sure to feed them through correctly. Nothing worse than having the cable on only to find it is in the wrong way. :'(
Enjoy
And as Red says plenty of time and cups of tea :thumbup
Thanks Unfazed!
Good idea about tightening the screws on the air box to keep it back.
Wish I thought of that trying to get them out.
Also good tip about the WD40 too
Thanks again