(05-01-15, 07:09 PM)unfazed link Wrote: Unless you have access to the special tool it is a carbs off job. :'(
You will not have to remove them completely, you could leave the throttle cables attached and lift the carbs up through the frame enough to get at the screws.
Are you sure the pilot jets are clean?
Hiya,
Not sure at all.
In fact as it was standing it's likely that they are fouled, though I did put some Redex in the tank to try and clean them a bit coz the instructions said that it should clean carbs.
But this made no difference. Also, do you have a pic or link to the tool you're talking about?
Thanks again