01-11-14, 10:47 PM
Didn't manage to get too much done today as we had an afternoon out followed by a fireworks display. Did spend over an hour setting up the cam timing had to change the cam sprockets because when the old chain skipped it rounded the teeth off, after getting it almost bang on first time I looked down and realised the crank was about 20 degrees out so had to take the cams out again, reset the crank then spent ages fiddling around one tooth this way, two teeth that way. Finally done, spun twice by hand and lined up perfectly. Slipped the carbs back in fiddled with the throttle cables until I realised that I could put them on before putting them in the frame!