08-10-14, 09:48 AM
I had similar concerns about the mount and didn't really like the tellytubby look of a top mounted gopro. I made one for the mobius by cutting the bottom off a lunchbox, heating it gently so I could form it into a slight curve. I then cut a "cradle" out of some half inch thick neoprene that the camera sits in snugly. I glued this to the lunchbox bottom with evostick and used double sided tape to stick the whole lot to the helmet. A bit of tape holds the camera in place (duck tape or whatever), it looks pretty good and is a bit more discreet than something mounted off the helmet.
I have had this on for a while now and it works well, I often remove the camera to put it in the car/aeroplane etc. The foam is now showing a bit of wear as the tape pulls a "skin" off when you remove it, I have thought about integrating some sort of screw to hold it in place...
I have had this on for a while now and it works well, I often remove the camera to put it in the car/aeroplane etc. The foam is now showing a bit of wear as the tape pulls a "skin" off when you remove it, I have thought about integrating some sort of screw to hold it in place...
Intentionally left blank