02-10-14, 12:56 PM
Go back to phillips screwdriver but before trying to turn it give it a couple of sharp taps on the top of the handle, helps it to dig back into the screw and may shock the joint a bit ?
Mole grips end on & very tight ?
Cut a slot across top with hack saw and use flat screwdriver ?
center punch and hammer on an end of a flat ?
Oh, drill it, but dont use drill any bigger than the threaded part, and you should not damage any of the crimpsÂ
Mole grips end on & very tight ?
Cut a slot across top with hack saw and use flat screwdriver ?
center punch and hammer on an end of a flat ?
Oh, drill it, but dont use drill any bigger than the threaded part, and you should not damage any of the crimpsÂ