Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Swingarm failure - torque arm mounting point
#35
(26-09-14, 03:28 PM)fazersharp link Wrote: No where does it say that you need to loosen the arm bolts when adj the chain slack, I have the origional owners manual and here is the online service guide that I downloaded from this forum

Yes but you are quoting a yamaha SHOP manual . it assumes a working level competence within the shop bay at the DEALER garage. All staff undergo general yamaha centric DEALER/franchise training and this sort of document is merely a guide for THE SPECIFIC BIKE MODEL. I mean this shop manual doesnt say a lot of things in a lot of areas; you are better off with a Haynes if you are new to Yamahas or indeed perhaps new to bike DIY in general. Otherwise this shop manual is okay but not a prescriptive line by line 101% step by step noddy guide so watch out  :rolleyes

Of course my friend, the litmus test is to repeat your test again once the bike is all good to go and come back and tell us what happened after a few 000s miles !!! It is entirely your decision as to  whether you take the advice on offer above from foccers - or not  :z
Three lefts make a right
Reply


Messages In This Thread
Re: Swingarm failure - torque arm mounting point - by MC680x0 - 26-09-14, 04:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)