10-09-14, 12:04 AM
just to add a bit of detail,
the tool I am using requires 7CFM but I'm not sure if that is FAD or DISPLACEMENT?
Compressors are quoted in DISPLACEMENT CFM but the FAD is what it actually delivers , no ? , so when looking for a compressor should I be looking for compressors with a DISPLACEMENT CFM of around 13-15??
The application for the compressor will be short bursts, say 10 to 20 seconds, of soda blast around bike parts (off the bike) so I'm thinking a 100 litre tank that displaces around 200 litres per minute at around 7 CFM DISPLACEMENT, would allow 30 seconds of blast before the compressor kicks in and i have to wait 30 seconds for the tank to fully recharge?
Is this powerful enough?
http://www.sipuk.co.uk/sip-06245-airmate...essor.html
the tool I am using requires 7CFM but I'm not sure if that is FAD or DISPLACEMENT?
Compressors are quoted in DISPLACEMENT CFM but the FAD is what it actually delivers , no ? , so when looking for a compressor should I be looking for compressors with a DISPLACEMENT CFM of around 13-15??
The application for the compressor will be short bursts, say 10 to 20 seconds, of soda blast around bike parts (off the bike) so I'm thinking a 100 litre tank that displaces around 200 litres per minute at around 7 CFM DISPLACEMENT, would allow 30 seconds of blast before the compressor kicks in and i have to wait 30 seconds for the tank to fully recharge?
Is this powerful enough?
http://www.sipuk.co.uk/sip-06245-airmate...essor.html
Three lefts make a right