26-08-14, 08:49 AM
Just as a sanity check, when you do the final tightening, if you are kneeling behind the rear wheel are you pushing the wrench from 11/12 o'clock or pulling it from 6 o'clock?
The phrase I was thinking of this morning when saying two flat surfaces I was meaning two parallel surfaces (being the clamping sides of the swingarm). If there is a missing spacer (or one that's too short etc) then when you tighten the nut it will pull the swingarm in, creating a ramp away from the swingarm pivot, this could cause it to move back as you are seeing.
The phrase I was thinking of this morning when saying two flat surfaces I was meaning two parallel surfaces (being the clamping sides of the swingarm). If there is a missing spacer (or one that's too short etc) then when you tighten the nut it will pull the swingarm in, creating a ramp away from the swingarm pivot, this could cause it to move back as you are seeing.
Intentionally left blank