04-08-14, 02:03 PM
(04-08-14, 01:48 PM)Arfa link Wrote:http://www.beginnerbiker.com/2014/06/fit...-calipers/ok pal.
Dead easy swap. Just a spot of filing in two spots. Took about half hour with mini Dremel-esque sander and a hand file Bolt it on at rear, then swing it up, it'll be very obvious where it needs to be filed. Emijaydee pics make it very clear too. You'll find it hard going with just sand paper, do yourself a favour and pick up some files from local store. Pick up some fresh Brake fluid whilst you're there, it'll only cost you a fiver-ish - no point going through hassle of bleeding brakes etc, and sticking old fluid in.
The mount is cast Aluminium so no need to touch it up with paint.
Note the caliper won't sit perfect centre on the disc, you'll need to pop in a small washer on each bolt to get alignment spot on
any chance of pics of washers in situ or how/where to apply - forgive me but as I answer electrical/technological problems and have lots of electronic test equipment to hand, my mechanics are still on a learning curve.