21-07-14, 04:03 PM
Both bolts are to secure the caliper. The rear caliper has 3 anti rattle shims, 2 behind the pads and one where the pads tough the caliper body at the 'front' end. The two bolts have 12mm and 14mm heads and both have rubber seals to prevent ingress.
I know some will disagree with this, but I always use copperslip to prevent electrolytic corrosion of the threads, and I tighten them up pretty tight. The fronts should be good and tight.
The workshop amnual says:
27nm front caliper bolts.
22nm rear caliper bolts.
I know some will disagree with this, but I always use copperslip to prevent electrolytic corrosion of the threads, and I tighten them up pretty tight. The fronts should be good and tight.
The workshop amnual says:
27nm front caliper bolts.
22nm rear caliper bolts.