31-05-14, 11:21 PM
(31-05-14, 10:30 PM)dazza link Wrote: Fitted the Gillies rearsets I got off of Brooker81, looked like a Chinese puzzle at first with all the bits and bobs, had to adjust the gear lever as it was too high for my liking, then the brake light switch as it was on all the time. Also had to put a short length of black hose on the side stand so I can get to it with my boots on. Centre stand just hits the gear lever side so temporarily wrapped a bit of insulation tape round the stand and rearsets to prevent it from marking until I can adjust them, don't really want to lose the centre stand....But, quite worryingly as usual had some bits left over. Can anyone throw some light on what these are for ? More concerned about the long internally threaded bush.
Probably an extensiion for the gear lever mate, if you adjust the footpegs to extremes you'll find the current bar is too long/short to adjust the lever properly, so its to sort that out
