Headrace bearings

[Sannox]

4pm and all the shells off, inc the one on the stem, that was the easiest, with an angle grinder, the heat from grinding helped as it's a very direct heat, the one thing to do is use a dremmel to create your own notches under the top shell then use the angled screwdriver as in the link from Fazerider, it makes life so much easier, the bottom shell drops out, I used the old shels to tap in the new taper shells, just take time and make sure you start them off square and tap all the way round evenly.

Now to put it all back together, give me 5 :-)