16-03-14, 03:15 AM
Yes. Feed through from the servo end and solderless nipple at the exup valve end.
I found that feeding the cable through was much easier if I pulled the outer cable out of the servo and back across to the right of the bike. Then, once it's in, thread back through to the servo.
I tried to pull through some nylon thread when removing the old inner cable but it got stuck at some bend that probably wouldn't be there if you took the top part of the outer out of the servo.
Haynes manual is next to foc-all use.
I wish they said things like 'Undo the 10mm nut on the flange' rather than 'Undo the thing (see picture)'.
I found that feeding the cable through was much easier if I pulled the outer cable out of the servo and back across to the right of the bike. Then, once it's in, thread back through to the servo.
I tried to pull through some nylon thread when removing the old inner cable but it got stuck at some bend that probably wouldn't be there if you took the top part of the outer out of the servo.
Haynes manual is next to foc-all use.
I wish they said things like 'Undo the 10mm nut on the flange' rather than 'Undo the thing (see picture)'.