Project Fazer: The build thread

[ChristoT]

[quote author=ChristoT link=topic=11731.msg132720#msg132720 date=1394306157]It's certainly narrower, though.  It's not as bad as I though, but I would approximate it being about 10mm out. To boot, the bearings were too small to take the swingarm pivot, so I was unable to bung it in place to measure more accurately.

You didn't honestly expect them to be a straight swap did you?  I bet the chain run won't line up either.

But, as I told you, I think you are bonkers for even considering it......
[/quote]

I was expecting the spacers and the suspension, but not the bearing diameter.

Not sure about the chain, but expecting to have to adjust it.