Fazer Owners Club - Unofficial › Bikes, Hints'n'Tips › FZS600 Fazer v
Break or mend?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Break or mend?
Revilo18 Offline
DAS Born Again
**
Posts: 96
Threads: 12
Joined: Sep 2011
View Submissions | Download History
#12
04-03-14, 09:35 AM
This is v encouraging. At my local shop as I write. Will let you know.

Renthals were fairly straight forward. Only tricky bit is drilling the hole for the plastic studs from the controls to sit in. Measure twice or drill twice as I did.
See you on the A3...
Find
Reply


Messages In This Thread
Break or mend? - by Revilo18 - 03-03-14, 10:12 PM
Re: Break or mend? - by Sloth - 03-03-14, 10:19 PM
Re: Break or mend? - by noggythenog - 03-03-14, 10:20 PM
Re: Break or mend? - by Deefer666 - 03-03-14, 10:24 PM
Re: Break or mend? - by Revilo18 - 03-03-14, 10:55 PM
Re: Break or mend? - by Dead Eye - 03-03-14, 10:59 PM
Re: Break or mend? - by Sloth - 03-03-14, 11:49 PM
Re: Break or mend? - by Dead Eye - 04-03-14, 01:45 AM
Re: Break or mend? - by Sloth - 04-03-14, 01:54 AM
Re: Break or mend? - by darrsi - 04-03-14, 01:59 AM
Re: Break or mend? - by Deefer666 - 04-03-14, 06:53 AM
Re: Break or mend? - by Revilo18 - 04-03-14, 09:35 AM
Re: Break or mend? - by Revilo18 - 04-03-14, 12:31 PM
Re: Break or mend? - by Dead Eye - 04-03-14, 12:53 PM
Re: Break or mend? - by Deefer666 - 04-03-14, 01:23 PM
Re: Break or mend? - by Buzz - 04-03-14, 01:32 PM
Re: Break or mend? - by Mattsplat - 04-03-14, 01:38 PM
Re: Break or mend? - by Deefer666 - 04-03-14, 01:43 PM
Re: Break or mend? - by Revilo18 - 04-03-14, 01:48 PM
Re: Break or mend? - by Deefer666 - 04-03-14, 01:56 PM
Re: Break or mend? - by Revilo18 - 04-03-14, 02:07 PM
Re: Break or mend? - by ChristoT - 04-03-14, 03:23 PM
Re: Break or mend? - by Deefer666 - 04-03-14, 05:52 PM
Re: Break or mend? - by Revilo18 - 05-03-14, 10:42 AM
Re: Break or mend? - by Wookee - 05-03-14, 11:49 AM
Re: Break or mend? - by Deefer666 - 05-03-14, 03:10 PM
Re: Break or mend? - by Revilo18 - 06-03-14, 12:57 PM

Forum Jump:


Users browsing this thread: