Torque wrench

[Dead Eye]

I have 3 at the moment;

1/4" (forget manufacturer) which is 10Nm to 30Nm
1/2" Silverline which is 42Nm to 210Nm
1/2" Draper (with certificate) which is 30Nm to 210Nm

I tend to use the Draper one the most and the majority of its use comes from cars more than anything. To undo bolts, I have a 1/2" drive 750mm Breaker Bar which usually gets the job done... access can get a bit fiddly with that thing though :\

The majority of my sockets are 3/8" inch or 1/4" and I always try to use the 6 point versions before resorting to the 12 point (I have far too many sockets...)

Edit: Also just found this; http://www.amazon.co.uk/Draper-30357-Mic...que+wrench - its on offer at the moment for £28.75 so its at a very good price imo