18-01-14, 05:48 PM
Hi all, I have a 99 fzs600 which i bought with around 27000 miles on. It had been standing and was spluttering a bit below 3000 rpm. Took carbs off to clean and found one of the pilot screws was broken. Could not get it out so fitted a 2nd hand set of carbs.
Runs beautifully above 3000rpm but is rough below. Just wondering if there is a common issue with fazers or is it just a case of needing to clean the "new" bank of carbs. They were supposedly off a recently running bike.
Have also changed plugs and plug caps but no difference. After a ride all exhaust temps sit at around 120 - 160 deg C except for cyl 3 which is at about 80 deg. So i am guessing cyl 3 is not getting fuel or firing below 3000 rpm.
Thanks in advance! Craig
Runs beautifully above 3000rpm but is rough below. Just wondering if there is a common issue with fazers or is it just a case of needing to clean the "new" bank of carbs. They were supposedly off a recently running bike.
Have also changed plugs and plug caps but no difference. After a ride all exhaust temps sit at around 120 - 160 deg C except for cyl 3 which is at about 80 deg. So i am guessing cyl 3 is not getting fuel or firing below 3000 rpm.
Thanks in advance! Craig