My experience - OEM C&S kit fitted with no issues. I wouldn't be bothered or surprised if an aftermarket part didn't have the same tolerances, I'd prefer a tighter fit over a slack one as long as the retaining nut properly tightened up the sprocket on the shaft, after a few thousand miles of wear I'm sure the sprocket will come off easily enough.
Fazer Owners Club - Unofficial
›
Bikes, Hints'n'Tips
›
Fazer 1000/FZ1 corner
Getting front sprocket back on the shaft Gen 1 Thou
Getting front sprocket back on the shaft Gen 1 Thou
|
Getting front sprocket back on the shaft Gen 1 Thou
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Getting front sprocket back on the shaft Gen 1 Thou - by Camshaft - 08-12-13, 07:30 AM
Re: Getting front sprocket back on the shaft Gen 1 Thou - by Dead Eye - 08-12-13, 11:52 AM
Re: Getting front sprocket back on the shaft Gen 1 Thou - by Camshaft - 09-12-13, 10:37 AM
Re: Getting front sprocket back on the shaft Gen 1 Thou - by Tmation - 09-12-13, 11:21 AM
Re: Getting front sprocket back on the shaft Gen 1 Thou - by Camshaft - 09-12-13, 11:37 AM
Re: Getting front sprocket back on the shaft Gen 1 Thou - by pitternator - 19-12-13, 07:39 AM
Re: Getting front sprocket back on the shaft Gen 1 Thou - by PieEater - 19-12-13, 08:42 AM
|
Users browsing this thread: