18-11-13, 10:48 PM
I would be amazed if it had distorted the hole it the gearbox shaft :eek , so I assume it is just the oil seal hole that has distorted. In which case just remove the retaining plate and replace the seal.
If you can't get the rest of the push rod out from the sprocket end you will need to partly dismantle the clutch and push it from that end. Either way don't lose the ball bearing at the clutch end of the push rod.
If you can't get the rest of the push rod out from the sprocket end you will need to partly dismantle the clutch and push it from that end. Either way don't lose the ball bearing at the clutch end of the push rod.