Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FZS600 Project. A Bike Called Polly
#43
Thanks again Nick.

Durability is a very real worry. I don't think it'll be all that resistant to stone chips to be honest. I've read about people getting good results from a couple of coats of clear lacquer over the vinyl. But it's too cold in my garage to try that at the mo!

At least I have plenty of offcuts. So worst case,  any chips can be patched. Up until the point it starts to look awful!!

And at the end of the day,  the vinyl for all the panels done so far has cost less than £20. So with patches and extra graphics,  it could become an organic and ever changing beast! !
Reply


Messages In This Thread
Re: FZS600 Project. Part 1 - by apage16 - 25-10-13, 11:04 AM
Re: FZS600 Project. Carbonating a Fazer... - by apage16 - 27-10-13, 11:04 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)