Clutch - Loud Noise

[darrsi]

Should have included the size. :rolleyes
Bolts they are M5 x 0.8 and are 9mm in length is is threaded the full length from the head of the bolt. The threaded hole on the sprocket cover is only 7.5mm deep and the mechanism is 2 mmm thick where the bolts are located. The best option is to use allen bolts as there is very little space. For those who have mangled the head of the bolts like I did a few times :eek , drill a 3 mm hole into the bolt with a left hand drill bit and if the bolt doe not spin out hammer a small torx bit into the hole while the bolt is still warm is the easiest way to undo them.

Don't s'pose you would know bearing size?