FZS600gRR unreleased model

[Punkstig]

Great tip on the sprocket from Talon. Thank you.  :thumbup  I didn't know that you could do that. I'll definitely need one of those.


Rather than cut down the spacers on the frame I was going to cut down the swing arm as there is enough metal there to remove. Not sure how to do it, hoping the tutor at my welding class can advise. That way if the swing arm doesn't work I can try another. I had thought about some inserts and may use them, but I'm going o try and find the correct size roller bearings with smaller inside diameter to take the standard spindle.


Are you able to explain the offset to me please, as per below?

[quote author=Ruby Racing link=topic=9638.msg102879#msg102879 date=1379698535]
This is new territory for me, so sorry if this is a dumb question, but is the wheel offset the distance from the centre of the rim to the centre line of the rear sprocket? If so the wheel I plan to use is about 10mm wider taking that measurement. Just a quick check with a tape measure, nothing highly accurate.

[/quote]


Surely the point of shaving the spacers instead of the swing arm is they are a shit load cheaper to replace if any mistakes are made,  not only that but an unmolested swingarm will have a higher resale value than a shaved one!