20-09-13, 08:33 AM
(This post was last modified: 20-09-13, 08:49 AM by fazersharp.)
Been looking at torques and there are only 3 places I am ever going to go over my 60nm so think I will be going for a olwer cost one, thinking if they are not as acurate then no matter as anything 80 90 120nm aint ognna break if its a bit tighter, - unlike somthing that needs to be 20nm.
So ive got my new nut and ys it has an extra 3 threads but look at my picture as I have hardly any threads left showing and what is there tapers so wont be doing anything so by a bigger nut Im not gaining anything.
Gonna start a new thread
"How thick is your shaft"
So ive got my new nut and ys it has an extra 3 threads but look at my picture as I have hardly any threads left showing and what is there tapers so wont be doing anything so by a bigger nut Im not gaining anything.
(18-09-13, 10:40 PM)TonyW link Wrote: Nut job done.Not measured my shaft yet but tony w says his 98 is 17.9, could that be the reason 98s are ok as we 98s have thicker shafts than everyone elseThe original nut wasn't loose but wasn't as tight as I was expecting. I took the time to measure the shaft thread, it was 17.9mm so chucked on some bearing retainer and the new nut went on at 80Nm.
Gonna start a new thread
"How thick is your shaft"
I don't do rain or threat there of. dry rider only with no shame.