FZS600gRR unreleased model

[Ruby Racing]

the Gilles rear sets are specifically for the FZS600, luckley the mille wheel has 10mm more offset than on the fazer but its not a straight swap as you will need a new swing arm  as the stock will not take anything  wider as far as i know ,the linkage mounts on the mille arm also need modifying  as well as the frame as the arm is wider there are 2 spacers on the inside of the frame that need trimming down also the gear box sprocket cover needs moddifing for chain clearance  most of my pix are on photobucket just follow the link , i have not as yet uploaded the latest for the new head lights

[size=78%]http://s1124.photobucket.com/user/wraith...t=6&page=1[/size]

Thanks for the info, much appreciated.


I've got an EXUP swing arm lined up, but it's 10mm too wide to fit between the frame. I plan on getting 5mm shaved off each side of the swing arm, I just don't know if that's possible or not yet. I went for another Yamaha one in the hope the linkages would line up. Certainly the width of the linkage hole on the swing arm is the same and bolt diameter is the same, so that makes life easier.


Why did you need to cut down the gear box sprocket cover? Did you need to space the sprocket out a bit to clear the tyre? Sorry just re read your previous post and see you had to space the sprocket out by 10mm. I assume that was the front one in order for the chain to clear the tyre and/or line up with the rear sprocket?