Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Where has me nut post gone then !!
#34
Nut job done.  Big Grin  The original nut wasn't loose but wasn't as tight as I was expecting. I took the time to measure the shaft thread, it was 17.9mm so chucked on some bearing retainer and the new nut went on at 80Nm.
Reply


Messages In This Thread
Re: Where has me nut post gone then !! - by TonyW - 18-09-13, 10:40 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)