30-08-13, 04:30 PM
Move the e-clip from the middle groove to the second from the top.
Put one of the original washers under the e-clip, then the 3mm nylon spacer, then the other washer.
Refit to throttle slide, press down the needle holder and make sure it's squarely in place. Push the needle up a few times to seat the spring.
Put one of the original washers under the e-clip, then the 3mm nylon spacer, then the other washer.
Refit to throttle slide, press down the needle holder and make sure it's squarely in place. Push the needle up a few times to seat the spring.