Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Anyone fitted CNC shorty levers to their fzs600?
#36
TNT try it on every time, even when the value is clearly under £15. Nice little illegal profit for them. How many people who are unaware of the rules just pay up? See my reply at http://foc-u.co.uk/index.php/topic,8866....l#msg88314 They never even bothered to reply. Just don't pay it.
As to the clutch switch, yes they seem to make the plate a big bigger, so it doesn't cut in. If so, just clip a little bit off the switch plunger with some pincers. About 2mm at a time until the plunger comes out far enough to allow a start.
Reply


Messages In This Thread
Anyone fitted CNC shorty levers to their fzs600? - by Fizzy Pies - 22-07-13, 10:05 PM
Re: Anyone fitted CNC shorty levers to their fzs600? - by mtread - 27-08-13, 10:14 PM

Forum Jump:


Users browsing this thread: