The lugs don't make it difficult to remove the throttle, its just a locating pin that stops the entire throttle twisting when you twist the throttle, people file this pin down instead of measuring it up on the new bars which would then need drilling to accommodate the pin, if you go that route then you'll need something decent like no more nails double sided foam tape to stop everything twisting.
The whole thing is removed by just undoing a couple of screws, you can either undo them partially enough for the pin to come loose of the hole and slide the whole unit off (if all wires are long enough) or undo the screws completely and let the 2 halves come apart!
The whole thing is removed by just undoing a couple of screws, you can either undo them partially enough for the pin to come loose of the hole and slide the whole unit off (if all wires are long enough) or undo the screws completely and let the 2 halves come apart!
Some say...