|
oil leak
|
10-08-13, 02:54 PM
Well I've got the new seal in after a load of farting about trying to get the rotor off. Hopefully it seals and I never have to do it again but my question now is I've tighten the centre bolt that holds the rotor on onto the crank to the recommended torque. Can I assume that the rotor is now pressed back far enough onto the crank since the bolt is tightened to the recommended torque?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
oil leak - by His Dudeness - 11-05-13, 09:59 PM
Re: oil leak - by Gnasher - 11-05-13, 11:23 PM
Re: oil leak - by unfazed - 12-05-13, 12:19 AM
Re: oil leak - by Gnasher - 12-05-13, 05:27 AM
Re: oil leak - by His Dudeness - 13-05-13, 09:41 PM
Re: oil leak - by unfazed - 14-05-13, 12:10 AM
Re: oil leak - by Dead Eye - 14-05-13, 01:48 AM
Re: oil leak - by His Dudeness - 14-05-13, 08:37 PM
Re: oil leak - by Dead Eye - 15-05-13, 12:38 AM
Re: oil leak - by His Dudeness - 25-05-13, 10:41 AM
Re: oil leak - by His Dudeness - 26-05-13, 07:40 PM
Re: oil leak - by His Dudeness - 29-05-13, 05:42 PM
Re: oil leak - by His Dudeness - 02-06-13, 07:03 PM
Re: oil leak - by bandit - 02-06-13, 10:20 PM
Re: oil leak - by His Dudeness - 03-06-13, 12:51 AM
Re: oil leak - by His Dudeness - 10-08-13, 02:54 PM
Re: oil leak - by nick crisp - 10-08-13, 04:39 PM
Re: oil leak - by unfazed - 11-08-13, 01:02 AM
Re: oil leak - by His Dudeness - 11-08-13, 03:23 PM
|
