handlebars

[stevierst]

If you do buy rentec or similar and think about grinding down the locating pins on the controls use something like no more nails double sided padded tape to wrap around the bar and keep the controls from twisting out of position!


I'd suggest not grinding the pin for the throttle housing, use a dab of copper grease on the pin to make a mark where to drill on the bars!

Not sure what bike you have, bit if its an fzs600, then you can't go wrong with Renthal 758. Very close to the standard bars, but with a bit less sweep, and a little bit wider. I've had them on 2 of my fzs600's, simply superb!
As for the locating pins, punkstig is right, even though I took the throttle pin almost flush, just allowing it to grip the bars and stop it slipping. I used zinc oxide tape out of my medical kit. One layer under the switchgear stopped it moving. 8)