20-07-13, 10:37 PM
T25 tamper proof torx driver (with the hole in the middle).
Get bike up to running temperature.
Turn engine off then switch key back on.
Unplug TPS then plug back in so it goes to the 10k mark.
Undo 2 screws on TPS just enough to be able to pivot the unit.
Move it until you get it bang on 5000rpm, then tighten screws.
DO NOT TURN KEY TO OFF POSITION WHEN AT 10,000rpm.
You will regret it, 'cos the needle will drop clockwise, then you'll have to open up the clocks to manually push the needle back round.
It's not a major, just bloody annoying (twice in my case :rolleyes)
Get bike up to running temperature.
Turn engine off then switch key back on.
Unplug TPS then plug back in so it goes to the 10k mark.
Undo 2 screws on TPS just enough to be able to pivot the unit.
Move it until you get it bang on 5000rpm, then tighten screws.
DO NOT TURN KEY TO OFF POSITION WHEN AT 10,000rpm.
You will regret it, 'cos the needle will drop clockwise, then you'll have to open up the clocks to manually push the needle back round.
It's not a major, just bloody annoying (twice in my case :rolleyes)
More people are born because of alcohol than will ever die from it.