Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mixture screw leaking
#7
The left two are easy.. the far right one is easy...the right hand middle one is easier if you remove the starter motor (Only two 8mm bolts)

I use a little screwdriver bit,you know the type that go into the end of screwdriver shaped ratchet? I just get it into position on the screw then remove it and mark it with a little line of say red electrical tape then you know how many turns you have done. Little hands helpĀ  Big Grin
Reply


Messages In This Thread
Mixture screw leaking - by Kentish - 17-06-13, 06:24 AM
Re: Mixture screw leaking - by Mark YPVS - 17-06-13, 03:14 PM
Re: Mixture screw leaking - by Kentish - 17-06-13, 06:45 PM
Re: Mixture screw leaking - by Mark YPVS - 17-06-13, 08:07 PM
Re: Mixture screw leaking - by Kentish - 17-06-13, 08:32 PM
Re: Mixture screw leaking - by Mark YPVS - 17-06-13, 09:01 PM
Re: Mixture screw leaking - by Kentish - 17-06-13, 09:08 PM
Re: Mixture screw leaking - by Mark YPVS - 17-06-13, 09:27 PM
Re: Mixture screw leaking - by Kentish - 18-06-13, 09:08 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)