Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Usd Conversion
#3
(09-06-13, 09:11 PM)simonm link Wrote: Does it rev beyond 10,000 ?

Looks good tho.


Not sure, The clocks go upto 18k.


Is there a limiter built into the original clocks? I pushed it fairly hard last night. This speedo has a top speed and rpm recorder, it said at my max rpm was 9900 and something.. Not sure on the Speed as the speedo wasn't properly calibrated then.


Also, to add, Rear wheel will be getting replaced by a Thunderace rim, So it will have a 180 on the back. Have a Hugger from a Srad that i can modify to fit too.


Now, the wheels.. they will be getting powder coated and new tires, What colour.. Black is the favorite, but i think silver would look pretty cool. Opinions?


Cheers, Tom
"Its a Fazer Jim, but not as we know it"
Reply


Messages In This Thread
Usd Conversion - by Superfour Tom - 09-06-13, 08:23 PM
Re: Usd Conversion - by simonm - 09-06-13, 09:11 PM
Re: Usd Conversion - by Superfour Tom - 09-06-13, 09:16 PM
Re: Usd Conversion - by simonm - 09-06-13, 09:50 PM
Re: Usd Conversion - by Superfour Tom - 09-06-13, 09:54 PM
Re: Usd Conversion - by simonm - 09-06-13, 09:54 PM
Re: Usd Conversion - by Superfour Tom - 09-06-13, 10:04 PM
Re: Usd Conversion - by Punkstig - 10-06-13, 01:25 PM
Re: Usd Conversion - by Superfour Tom - 10-06-13, 01:50 PM
Re: Usd Conversion - by Punkstig - 10-06-13, 02:57 PM
Re: Usd Conversion - by Superfour Tom - 11-06-13, 01:17 AM
Re: Usd Conversion - by Punkstig - 11-06-13, 09:43 AM
Re: Usd Conversion - by Motorbreath - 11-06-13, 01:28 PM
Re: Usd Conversion - by Superfour Tom - 22-06-13, 03:24 AM
Re: Usd Conversion - by Superfour Tom - 24-06-13, 12:07 AM
Re: Usd Conversion - by Superfour Tom - 02-07-13, 12:18 AM
Re: Usd Conversion - by Superfour Tom - 02-07-13, 03:17 PM
Re: Usd Conversion - by simonm - 02-07-13, 05:15 PM
Re: Usd Conversion - by nick crisp - 02-07-13, 06:17 PM
Re: Usd Conversion - by simonm - 02-07-13, 06:23 PM
Re: Usd Conversion - by Superfour Tom - 02-07-13, 07:50 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)