Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cost of a new Cam chain?
#11
cam chain can slip a couple of teeth before doing any damage  Smile .take the rocker cover off put the engine at TDC.ie align the mark on the flywheel and check the timing marks,adjust if needed and then do a compression test to see if theres any other damage,saves taking the head off and £30 for a new gasket  Wink ...good luck
One, is never going to be enough.....
Reply


Messages In This Thread
Cost of a new Cam chain? - by HazzaBui - 04-06-13, 11:42 PM
Re: Cost of a new Cam chain? - by Thorn - 05-06-13, 12:12 AM
Re: Cost of a new Cam chain? - by darrsi - 05-06-13, 06:30 AM
Re: Cost of a new Cam chain? - by Punkstig - 05-06-13, 10:24 AM
Re: Cost of a new Cam chain? - by kebab19 - 05-06-13, 11:17 AM
Re: Cost of a new Cam chain? - by Dead Eye - 05-06-13, 04:46 PM
Re: Cost of a new Cam chain? - by red98 - 05-06-13, 04:57 PM
Re: Cost of a new Cam chain? - by Skippernick - 05-06-13, 10:39 PM
Re: Cost of a new Cam chain? - by HazzaBui - 06-06-13, 12:08 AM
Re: Cost of a new Cam chain? - by Dead Eye - 06-06-13, 12:48 AM
Re: Cost of a new Cam chain? - by red98 - 06-06-13, 08:30 AM
Re: Cost of a new Cam chain? - by red98 - 06-06-13, 08:32 AM
Re: Cost of a new Cam chain? - by HazzaBui - 09-06-13, 05:28 PM
Re: Cost of a new Cam chain? - by His Dudeness - 09-06-13, 05:37 PM
Re: Cost of a new Cam chain? - by darrsi - 09-06-13, 05:38 PM
Re: Cost of a new Cam chain? - by red98 - 09-06-13, 06:56 PM
Re: Cost of a new Cam chain? - by Deefer666 - 11-06-13, 08:25 PM
Re: Cost of a new Cam chain? - by darrsi - 11-06-13, 08:39 PM
Re: Cost of a new Cam chain? - by Deefer666 - 12-06-13, 07:20 AM
Re: Cost of a new Cam chain? - by darrsi - 12-06-13, 07:37 AM
Re: Cost of a new Cam chain? - by Dead Eye - 12-06-13, 12:54 PM
Re: Cost of a new Cam chain? - by Deefer666 - 12-06-13, 06:07 PM
Re: Cost of a new Cam chain? - by darrsi - 12-06-13, 07:49 PM
Re: Cost of a new Cam chain? - by Deefer666 - 13-06-13, 07:11 AM
Re: Cost of a new Cam chain? - by darrsi - 13-06-13, 08:51 AM

Forum Jump:


Users browsing this thread: