24-05-13, 02:35 PM
The camchain dont rattle! :lol :lol :lol :lol
But seriously, by taking a measurement of where the original is extended to, and then setting it to that length. There is a way of doing this involving a thin flat bladed screwdriver, a ten mill spanner, a small steel ruler and marker pen. From then on, its just a question of playing it by ear I suppose. Not had any experience of manual ones, but this seems to be the method.
Getting the horrible feeling I'm becoming far too familiar with Gen 1 cam chain adjusters. Need to break the cycle, but not literally, again.
But seriously, by taking a measurement of where the original is extended to, and then setting it to that length. There is a way of doing this involving a thin flat bladed screwdriver, a ten mill spanner, a small steel ruler and marker pen. From then on, its just a question of playing it by ear I suppose. Not had any experience of manual ones, but this seems to be the method.
Getting the horrible feeling I'm becoming far too familiar with Gen 1 cam chain adjusters. Need to break the cycle, but not literally, again.
Its better to ask a stupid question than make a stupid mistake.