23-05-13, 10:18 PM
A follow up to my follow up... 
A while back I bought the Multifunction Hub which allows all sorts of add-ons to the PCIII, but the one I wanted it for was the Fuel Map switch which lets me swap between the "touring" map and the "fun" map to save fuel when I don't need the extra power.
The major hassle was that I didn't have a laptop which I needed to program the hub with the two maps but finally I managed to get my hands on one, although I did have to phone Dynojet up in the States to find out why, despite following their instructions, it wouldn't recognise the Hub was there. Turns out that instead of version 2.3.1 of the Firmware I needed 2.3.2!
I also had to get hold of a 9v battery to power the unit whilst reprograming the Firmware (you can change maps with the unit plugged in if the engine is running, but I was comprehensively warned you can't do that to change the Firmware as that will just turn it into a brick, meaning you need to buy a reprograming module too!)
Once I'd sorted the Firmware, it wasn't too hard to install two maps and then fit the switch to the handlebars to swap between them (which it can do on the fly!) when I want.
Once I'd done that I now have a switch on the handlebars to swap maps
A while back I bought the Multifunction Hub which allows all sorts of add-ons to the PCIII, but the one I wanted it for was the Fuel Map switch which lets me swap between the "touring" map and the "fun" map to save fuel when I don't need the extra power.
The major hassle was that I didn't have a laptop which I needed to program the hub with the two maps but finally I managed to get my hands on one, although I did have to phone Dynojet up in the States to find out why, despite following their instructions, it wouldn't recognise the Hub was there. Turns out that instead of version 2.3.1 of the Firmware I needed 2.3.2!
I also had to get hold of a 9v battery to power the unit whilst reprograming the Firmware (you can change maps with the unit plugged in if the engine is running, but I was comprehensively warned you can't do that to change the Firmware as that will just turn it into a brick, meaning you need to buy a reprograming module too!)
Once I'd sorted the Firmware, it wasn't too hard to install two maps and then fit the switch to the handlebars to swap between them (which it can do on the fly!) when I want.
Once I'd done that I now have a switch on the handlebars to swap maps