20-05-13, 06:42 AM
Not sure if this might apply to the 600 but I recently had the rear bearing fail on my 1000 and tapping/drifting the bearing out from inside didn't work as the inner race 'collapsed' out of the bearing leaving the outer race still stuck in the wheel (it was the left hand bearing). In the end I had to admit defeat and take wheel to a workshop in order to get what was left of the bearing out.
I replaced all three bearings in the end.
I replaced all three bearings in the end.
Someone sent me a postcard picture of the earth. On the back it said, "Wish you were here."
Steven Wright
Steven Wright