|
Exhaust studs
|
09-05-13, 02:29 PM
(09-05-13, 01:16 PM)elbrownos link Wrote: I'm just going to use stainless long nuts (actually stud connectors) on stainless studs, with copper grease both ends. Galling won't be an issue at 10Nm If you go that route, get some washers as well. I have the same nuts (connectors) but they are slightly too small so the flange begins to deform / eat the edge of the nut ![[Image: 242673.png]](http://badges.fuelly.com/images/smallsig-uk/242673.png) ![[Image: 174802.png]](http://badges.fuelly.com/images/smallsig-uk/174802.png)
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Exhaust studs - by elbrownos - 04-05-13, 04:55 PM
Re: Exhaust studs - by AdieR - 04-05-13, 08:00 PM
Re: Exhaust studs - by Fazerider - 04-05-13, 09:09 PM
Re: Exhaust studs - by Fuzzy - 05-05-13, 11:34 PM
Re: Exhaust studs - by Fazerider - 06-05-13, 09:21 AM
Re: Exhaust studs - by elbrownos - 08-05-13, 09:02 PM
Re: Exhaust studs - by simonm - 08-05-13, 09:05 PM
Re: Exhaust studs - by Dead Eye - 08-05-13, 10:08 PM
Re: Exhaust studs - by Fazerider - 08-05-13, 10:50 PM
Re: Exhaust studs - by Fuzzy - 09-05-13, 12:20 PM
Re: Exhaust studs - by elbrownos - 09-05-13, 01:16 PM
Re: Exhaust studs - by Dead Eye - 09-05-13, 02:29 PM
Re: Exhaust studs - by limax2 - 10-05-13, 08:56 AM
Re: Exhaust studs - by elbrownos - 10-05-13, 03:16 PM
Re: Exhaust studs - by Fuzzy - 12-05-13, 06:24 PM
|
