Bar End Weights

[ghostbiker]

yup both times i had wheels powdercoated i removed and replaced the bearings. the heat they would be subjected to would not only possably warp them but the grease would drip out and screw the powdercoating up i would think.

i replaced my rear with a nitron and loved it, i also run a jack up kit but when i fitted the jack up i had to take about 5 rings of preload of and play alot with the damping to find an aceptable feel. still not as good as it was before i fitted the jack up kit but at least my hips dont hurt now.
i also have a full Ktec front for rework. not sure off hand what springs they fitted off hand as its all in the papperwork though. i also dropped the forks 10mm.

so reowrked front forks by ktec
10 mm lower on front
nitron rear shock set up for no jack up kit but altered by me..... badly
jack up kit on rear
flat bars
ps3's fitted front and back running at 3-4psi under recomended on front and recomended on rear

i find the bike a little unstable at very tight low speed turns like jcts. the bike just falls away
but on the road with roundabouts and bends its rock steady. quicker steering than before by a long way but still stable.