|
End can shortening
|
29-03-13, 08:22 AM
I cut around 20mm from an old Micron can fitted to my FZ750 to remove some damage. The inner baffle also needed cutting down. There were 3 welds holding the baffle to the end cap so I ground them off first, cut baffle to length & welded it back on but it was such a tight fit I might have got away with not welding it.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
End can shortening - by Jimmygixxer - 29-03-13, 04:04 AM
Re: End can shortening - by GrahamB - 29-03-13, 08:22 AM
Re: End can shortening - by Skippernick - 29-03-13, 10:22 AM
Re: End can shortening - by Skippernick - 30-03-13, 05:22 PM
Re: End can shortening - by darrsi - 30-03-13, 05:52 PM
|
