29-03-13, 04:04 AM
Has anyone had an Micron exhaust of their FZS 600 and shortened it down before?
Being a Micron, mine has 3 bolts holding it together at the face of the end of the can. So i assume i would have to cut it in the middle and maybe reweld it, instead of the usual cut just a bit off the end with other cans which use rivets.
Also i was going to cover it in 3M Carbon vinyl wrap. I had a small piece and had it stuck to the underside of the can for a few weeks and it never melted or bubbled. But would it last if the whole thing was done and over a longer peroid of time over a maybe warm summer? :lol
Being a Micron, mine has 3 bolts holding it together at the face of the end of the can. So i assume i would have to cut it in the middle and maybe reweld it, instead of the usual cut just a bit off the end with other cans which use rivets.
Also i was going to cover it in 3M Carbon vinyl wrap. I had a small piece and had it stuck to the underside of the can for a few weeks and it never melted or bubbled. But would it last if the whole thing was done and over a longer peroid of time over a maybe warm summer? :lol