06-02-13, 12:39 AM
For starters, make sure your link pipe is the same diameter hole as the new end can and the downpipes, they're not all the same, as i found out when fitting mine!
If it's the same then it's just a jubilee clip to undo and a hanging bolt, hence the term "slip on".
Some people use a high temp silicone sealant to seal the join, i would personally avoid Gun Gum though as it's horribly messy to use and dries solid, so if you want to take it off later on you need to chip it all off.
If it's the same then it's just a jubilee clip to undo and a hanging bolt, hence the term "slip on".
Some people use a high temp silicone sealant to seal the join, i would personally avoid Gun Gum though as it's horribly messy to use and dries solid, so if you want to take it off later on you need to chip it all off.
More people are born because of alcohol than will ever die from it.